12
www.dimplex.com
Operation
High Heat and Off.
→ Activated by pressing the
button on the unit or the
remote.
• Indicated by the
(low heat)
or the
(high heat) icon and
the intake temperature being
displayed on the On Screen
Display, for 5 seconds before
turning off.
!
NOTE:
After the heater is
switched off, there is a 60 second
fan delay, where the fan will con
-
tinue running before turning off.
!
NOTE:
The unit can be oper
-
ated in
Heat Only Mode
. When
the unit is only running with the
heater, the
(low heat) or the
(high heat) icon
and the intake
temperature will continuously
be displayed on the On Screen
Display.
!
NOTE:
The heater may emit
a slight, harmless odor when first
used. This odor is a normal con
-
dition caused by initial heating of
internal heater parts and will not
occur again.
D & E. Thermostat Controls
Adjusts the temperature set point
to your individual requirements.
Once the desired set temperature
is reached the heater will turn off.
The heater will cycle on and off to
maintain the desired set tem-
perature. The default temperature
setting is 72°F (22°C).
→ Adjusted by pressing the
to decrease the setpoint
and the
to increase the
setpoint on the remote.
• The On Screen Display will in
-
dicate the temperature setpoint
as it is adjusted.
!
NOTE:
Holding the
button
down, then press
on the unit,
will change the temperature from
°C to °F, or vice versa.
Disable Heat
If desired, depending on the sea
-
son, the heater on the unit can be
disabled. The unit will operate in
the same fashion, with remainder
of the controls.
Pressing the and
buttons
on the unit at the same time and
holding for 2 seconds
will disable
and enable the heater.
!
NOTE:
When the heater has
been disabled and either the
