16
www.dimplex.com
Operation
Heater Lighting Instructions
1. Turn on the gas source.
2. Pull the red cord (on) continuously for 10 seconds
(Figure 14)
. A ‘click’ will be heard. The heater should
start. Release the cord.
3. If the burner does not ignite, turn off the gas source.
Wait at least 5 minutes for gas to clear, then retry.
If your heater still fails to light, turn gas source off.
Wait 5 minutes for gas to clear and then follow
the instructions for
Checking for Gas Leaks
on
page 15. If no leaks are detected, repeat the lighting
procedure.
Turning Off the Heater
1. Pull the black cord (off)
(Figure 14)
. A ‘click’ will be
heard.
2. If the heater does not turn off, repeat step one.
3. Turn off the gas supply.
4. When the heater is not in use, turn off the gas
source.
WARNING
• Before each use:
- Inspect the heater for nests or other debris that could ignite to avoid the risk of fire, serious injury, or
death.
- Check all hoses for cracks, nicks, cuts, burns or abrasions. If a hose is damaged in any way, do not use
your heater before replacing the hose with an authorized part from the Parts List. Failure to replace a
faulty hose, secure gas supply connections before proceeding to the
Heater Lighting Instructions
could
result in a fire or explosion that could cause serious bodily injury, death, or property damage.
- Also make sure all gas supply connections are securely tightened.
• Familiarize yourself with the safety and Operation instructions in this manual. Do not smoke while lighting
heater or checking gas supply connections.
• Always light the heater standing to the side of the heater, never light the heater standing in front.
Figure 14
Turn On
(Red)
Turn Off
(Black)
