7
Installation
WARNING:
Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of fire, electric shock or injury to
persons.
WARNING:
Construction
and electrical outlet wiring must
comply with local building codes
and other applicable regulations
to reduce the risk of fire, electric
shock and injury to persons.
WARNING:
Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
WARNING:
To reduce the risk
of fire, do not store or use gaso
-
line or other flammable vapors or
liquids in the vicinity of the heater.
CAUTION:
Clearance for air
circulation beneath the fire
-
place insert is provided by 2
rubber feet.
Do not install the fireplace
insert directly on carpet or
similar surfaces which may
restrict air circulation.
CAUTION:
If installing the
fireplace in a carpeted area, place
a one-piece, solid, flat surface
under the fireplace. Ensure that
both of the feet rest securely on
this surface.
!
NOTE:
The dimensions of the
firebox are 26 in. (661 mm)
wide X 18 ⅞ in. (480 mm) high
X 8 ¾ in. (223 mm) deep. The
firebox does not require any
additional venting.
Mantel Installation
Install the fireplace into the
mantel (refer to mantel assembly
instructions).
!
IMPORTANT:
If not using a
Dimplex mantel, the fireplace
must be installed in an enclosure
with the following
minimum
inter-
nal/opening dimensions - Figure
1.
Figure 1
9 in.
(229 mm)
24 ½ in.
(622 mm)
18 ¼ in.
(464 mm)
