13
Figure 6
Flicker
Rod
replace light bulbs. Care must be
taken when removing the log set.
To Access The Lower Light
Bulb Area:
(Figure 6)
CAUTION:
Allow at least 5
minutes for light bulbs to cool
before touching bulbs to avoid ac-
cidental burning of skin.
1. Remove front glass assembly.
2. Pull the back edge of the
plastic ember bed forward
until the rear tab releases
from the ledge located at the
bottom of the partially reflec-
tive glass.
!
IMPORTANT:
Only handle the
log set by the ember bed.
!
NOTE:
Log set fits tightly into
firebox, some force may be nec-
essary to remove.
3. Set log set in front of fire-
place.
Figure 7
Side Section
Front
Edge
Log
Ember
Bed
Back
Ledge
Rear
Tab
Maintenance
4. Disconnect the flicker rod
from the motor (see Figure 6).
5. Unscrew bulbs counter clock-
wise.
6. Insert new bulbs.
7. Reconnect the flicker rod to
motor.
8. Replace the log set by insert-
ing the front edge of the log
set and push down on the
rear edge of the ember bed
until it snaps into place (Fig-
ure 7).
!
NOTE:
Ensure the log set is
installed tightly under the back
ledge to prevent light leakage.
9. Replace glass assembly.
Glass Cleaning
The front glass is cleaned in the
factory during the assembly op-
eration. During shipment, instal-
lation, handling, etc., the front