4
ASSEMBLY & OPERATION
If your fan comes ready assembled ignore this section.
Assembly of your pedestal fan
1.
Separate the front and rear guard if they are connected.
2.
Remove the four position screws on the motor, offer up and align
the rear guard with the four holes on the motor (handle to top of the
fan) insert the four position screws and tighten.
3.
Loosen the set screw on the blade, slide the blade into the shaft of
the motor, and tighten the set screw onto the flat of the shaft to
secure the blade. Ensure that the blade does not foul the guards.
4.
Assemble the front guard to the rear guard. Tighten the screw and
nut, and secure the retaining slips.
5.
Loosen the set screws on the base plate with the spanner provided.
Attach the pole and re-tighten the screws back onto the base plate.
Operation of your pedestal fan
The power switch is incorporated in the speed control switch on top of the
fan.
0 – The fan is switched off.
1 – The fan operates at the lowest speed.
2 – The fan operates at medium speed.
3 – The fan operates at the highest speed.
To blow air in one direction and stop oscillation, allow the fan to move into
the desired position and pull the clutch knob up. Press the clutch knob down
to return to a normal oscillation function.
