Dimension One Spas 2003 Sarena Bay, Руководство пользователя

Страница: 34 / 56

2003 Sarena Bay
™
Export Owner’s Manual
Summer Mode
The “
SUMMER MODE ” feature temporarily disables the circulation pump
“Cool Off” cycle. During hot weather the spa can experience “Heat Creep”.
Heat creep is caused when the spa, during normal maintenance operations,
cannot dissipate more heat than is generated. This may cause the spa
temperature to exceed the set temperature and cause a “Cool Off” cycle. In
order to prevent the water from becoming cloudy due to the circulation pump
being turned off by the “Cool Off” cycle, the spa can be set to bypass the
“Cool Off” cycle. This is accomplished by setting the spa in the “
SUMMER
MODE ”.
To initiate a “
SUMMER MODE ”, use the Up and Down Buttons to set the
temperature to 15
°
C (
≅
59
°
F). The Digital Display Window will indicate
“ SUMMER MODE ”. In this mode the pump will run continuously until the
water temperature reaches 41
°
C (
≅
107
°
F) and then turn off. It will remain off
until the water temperature reaches 38
°
C (
≅
102
°
F) at which point the pump
turns on.
Standby Mode
The “
STANDBY ” mode allows the user to clean the filter without turning off
power to the spa. This feature disables all automatic and manual functions.
To enter the “
STANDBY ” mode press and hold the Dimension One Spa’s
ICON Logo
®
Button for 5 seconds. To exit the mode, press and hold the
Logo Button for 5 seconds.
If you do not exit the mode manually, the spa will automatically return to
normal functionality after 24 hours.
Note
The “
Smart Winter ” mode is not affected by the use of the
“ Standby ”: mode.
Programming the Scrolling Message Center
Your Scrolling Message Center is the most advanced in the industry and can virtually walk you through
customizing your hot tub to your exact needs. To initiate the programming sequence at any time, push and
hold the Program Button for 3 seconds. If, within 10 seconds, you do not proceed with the hot tub
programming, the hot tub will automatically exit the programming sequence and revert to the pre-set factory
default settings. To exit the programming sequence at any time, push the Enter Button or do not press any
button for 10 seconds. Any programming changes made up to that point are saved.
Setting the Time
After holding the PROGRAM Button , the top line of the Digital Display Window will read “ SET TIME OF
DAY ” and the bottom line will read “ PUSH UP OR DOWN TO CHANGE - PUSH PROGRAM TO
SELECT NEXT FUNCTION - PUSH ENTER TO EXIT ”. Push the UP or DOWN Buttons to engage the
time setting mode. The time screen will appear with “hours” (_ _.00) flashing on and off. Push the UP or
DOWN Button to increase or decrease the number until the desired hour appears. When the desired
number is displayed, push the LIGHT Button to accept the selection and change the flashing number to the
“ten minute” place (12:_0). Adjust the number with the UP or DOWN Button in the same manner as the
hour number. When the desired indicator is displayed, push the LIGHT Button to accept the selection and
change the flashing number to the “minute” place (12:1_). Adjust this number with the UP or DOWN
28