❖Accessories of Installation
Bracket for machine
Electrical cable
⑤
Emergency cable
Air hose
④
Air regulator
Bolts
①for the bracket
②for the machine
③pass line adjusting
②
④Bonding
①
Mark tube, Terminal
③
Sticker
Air connector
⑤Apron plate
❖Setting Items
Feed Length, Feed Angle, SPM
Release Mode
Changeable main screen in "Set" state.
Feed length
Release Mode
Setting method of table screen
Setting method of "Release Mode"
① Power
① Power
② ← →
Setting items can be changed.
③ + / -
The value can be Changed.
③ + / -
The value can be Changed.
After setting
Synchronous operation
Model
R30 R40 R50
Installation Manual
To display "Release Mode", push on "Sync
Release" switch in "Set" state.
Turn ON "Power switch"
"Release Mode" is not displayed in "Set" state.
Exclusive type
Feed
Angle
R30, R40, R50
Exclusive type
P6：8M
8M
2-M6*12
4-M14*30
8*5：6M
With air filter
Numeric value that can be changed item or
number will be blink.
② First, push on "Sync Release" switch, keep
it.
When "Sync Release" is turned off, the
display returns the main screen.
Press rotation speed
DIMAC
Net 4ml
4-M8*25
1-M12*120
1-3/8B, 2-2/8B
Numeric value that can be changed item or
number will be blink.
If you need to continue inputting, repeat
②,③.
Turn ON "Power switch"
Assortment
Signal(Feed/Release), Scale for
pass line (on the plate)
Description of good
Fixture for the air regulator
⑤
Sync Feed
Sync Release
Press the both switches of Sync-
Feed, -Release switches, then the
feeder will be able to operate
automatically.
④
Set ⇔ Run
Push "Set ⇔ Run" switch, when "Run" lamp is lit, the setting
finishes.
1
