Digium, Inc.
Page 38
Chapter 2: Unit Installation
server. The MAC address of the Gateway Series appliance is printed
on a label on the back of the unit. FTP and HTTP normally do not
require a username and password.
The Configuration Server options are specified below.
Reload Remote Config on Reboot - Leaving this option enabled will
allow the Gateway Series appliance to request that its configuration be
reloaded from a configuration server on every reboot.
Note: If this feature will not be used, it is recommended that it be
disabled.
Get Config Server from Option 66 via DHCP - If Obtain an IP
Address via DHCP is enabled and the DHCP server specifies the path
and configuration database file on the configuration server using
Option 66, this feature may be enabled for all Gateway Series configu-
ration settings to be automatically configured using a configuration
server. The Reload Remote Config on Reboot option must be
enabled in order to activate this feature. Refer to the note on page 37
for proper syntax when specifying the path and configuration database
file.
Configuration Server - If Obtain an IP Address via DHCP is
enabled and Get Config Server from Option 66 via DHCP is dis-
abled, the path to the configuration server may be statically defined
using this option. The Reload Remote Config on Reboot option must
be enabled in order to activate this feature. Refer to the note on
page 37 for proper syntax when specifying the path and configuration
database file.
