5
Installation for DS-55314 (Set)
1.
Install mounting ears if needed
2.
Connect Sender (TX) unit with HDMI® source and IR TX cable
3.
Connect Receiver (RX) unit with HDMI® TV/display and IR RX cable
4.
Supply power to both Sender and Receiver units
5.
The Power LED on both sides will light on
6.
The Status LED flashes slowly and waiting for pairing
7.
Display of the receiver shows "Searching TX"
8.
When Link and Status LED flash quickly, installation is completed
9.
If a local display is needed, connect another screen to the Sender unit anytime
Note:
3.5mm audio cable is used only when Sender and Receiver
pair settings is needed
Installation for DS-55315 (additional Receiver)
1.
Find 3.5mm male to male audio cable from accessory
2.
Connect the sender and receiver with the audio cable via IR port
3.
Connect sender unit with input device, connecting the receiver unit
with a display
4.
Supply power on both sender and receiver
Long press the “Reset” button for 10 second on the Receiver.
The display shows "searching TX"
5.
Short press the “Reset” button on both sender and receiver unit
to match the sender and receiver
6.
The Link and Status LED both will flash quickly. Settings completed
Note:
If you wish to connect more receivers, please repeat above steps
to match up to 4 receivers