Digitus DN-95639, Быстрое руководство по установке

Страница: 5 / 55

5
7. External connection annunciator
Use the supplied terminal to connect the annunciator, the terminal allows maximum
voltage of 50VDC and load current of 5A.
8. Ethernet connection (only intelligent type)
Use supplied network cable, connect one side to the NET port of device and the
other end to network.
Software user guide
1. Software configuration
1.1. Device default settings
Device default IP: 192.168.1.163
Default username: admin
Default password: admin
Note: Both the default username and password are in lowercase, user
cannot log on to the interface with uppercase.
1.2. Device configuration when first log in
•
Connect the device to PC directly.
•
Rework the network configuration of PC, make sure the changed PC IP
address and the IP of the ATS is in the same segment, the default of the IP
address is 192.168.1.163; Default subnet Mask is 255.255.255.0; Default
gateway is 192.168.1.1. For instance, change the network configuration of
the PC to IP: 192.168.1.145; log on to the management interface.
•
Click the "Network Config" on the left menu to rework the IP of the ATS,
see the below interface, change the IP address of the ATS and make sure it
is in the same segment where the PC IP is.
•
Restore the PC network configuration, Sign into the management interface
with the changed IP address of ATS.