10-INCH 8-PORT GIGABIT ETHERNET
PoE+ SWITCH, L2+ MANAGED
Quick installation guide
DN-95331
1.
About Guide
This guide provides instructions to install the PoE Switch.
Note:
The model you have purchased may appear slightly different from the
illustrations shown in the document. Refer to the Product Instruction and
Technical Specification sections for detailed information about your switch, its
components, network connections, and technical specifications.
This guide mainly divided into 4 parts:
1. About guide: Terminology/Usage
2. Product introduction: functional overview and introduction of panel definitions
3. Hardware installation: step by step hardware installation process
4. Technical Specifications
Terminology / Usage
In this guide, the term "Switch" (first letter capitalized) refers to the PoE Switch, and
"switch" (first letter lower case) refers to other PoE switches. Some technologies refer
to terms "switch", "bridge" and "switching hubs" interchangeably, and both are
commonly accepted for Ethernet switches.
Note:
indicates important information that helps a better use of the device.
Warning:
indicates potential property damage or personal injury.
Copyright and trademark
The pictures and data shown in this guide are for reference only, subject to change
without notice.
2.
Products Introduction
Thanks for purchasing the Managed PoE switch products
.
This product is a network management type Gigabit PoE Switch. The machine comes
with 8x 10/ 100/1000Mbps RJ45 PoE ports which can satisfy the full speed forwarding
of ports. The machine uses is a small size metal-shell device which is useful for the
small office can home and the IP solution project using, be used on the desktop or Wall
mounting. Excellent performance can help you widely use in wireless, monitoring and
other fields.
Front Panel
The front panel consists of LED indications and network ports
LED Lamp
Power LED:
The Power LED lights up when the switch is connected to a power source.
Link/Act indicator:
The light indicates the network connection through the
corresponding port. Flicker indicates that the switch is sending or receiving data
PoE indicator: C
onstant brightness indicates that the PD device is connected to the
corresponding port, and extinguished indicates that the port is not powered or no PD
device is found.
Side Panel
RST:
By pressing the Reset button for 5 seconds the switch will change back to the
default configuration and all changes will be lost.
Rear Panel
The rear panel view of the Ethernet switch consists of an AC power connector.
(1)
Grounding:
use specialized ground lead connect
(2)
Connect the power adapter output terminal to this port.
Supports input voltages 100-240VAC
3.
Hardware installation
This chapter provides unpacking and installation information for
the Managed PoE Switch.
Open a seal
Open the shipping carton and carefully unpack its contents. Please consult the packing
list located in the User Manual to make sure all items are present and undamaged.
If any item is missing or damaged, please contact the local reseller for replacement.
Switch 1pcs
User's manual 1pcs
AC power cord 1pcs
CD ROMs 1pcs
Switch installation
For safe switch installation and operation, it is recommended that you:
Visually inspect the power cord to see that it is secured fully to the
AC power connector.
Make sure that there is proper heat dissipation and adequate ventilation
around the switch.
Do not place heavy objects on the switch.
Installation hole spacing
Connecting power supply
Using the AC power cord to connect to of the into the AC socket on the back of the
switch.
Warning:
Do not turn on the power switch before power cables are connected.
Power surge may cause damage to the Switch.
Power failure
As a precaution, the switch should be unplugged in case of power failure.
When power is resumed, plug the switch back in.
