3
You have downloaded “IPScan.exe” in your laptop / PC.
Note:
Please download “IPScan.exe” from
www.surveillance-download.com/user/m328a.swf
.
Step1: Connect your laptop / PC to the wireless network with the camera connected.
Step2: Open “IPScan.exe” ( ) to search your camera. The default IP address of the camera is
192.168.1.10
.
If you connect two or more cameras to the wireless router, “IPScan” will list many cameras with different
IP addresses after searching. To know which camera you’re configuring, you may identify each with its
unique MAC address.
Note:
The MAC address can be found on the sticker at the bottom side of the camera.
Step3: Select the IP address you want to configure, and click “Configure” to show the IP setting page, and
change the IP address, gateway and port number.
For example, the IP address of your router is
192.168.2.1
. Then in this step, you need to change the IP
address to
192.168.2.xx
(“
xx
” means any value from 2 ~ 50), and change the gateway to “
192.168.2.1
(the same as the IP address of your router). Then, change the port number to any value other than 88 if
needed.
Note:
Make sure the IP address you change is not used by other devices connected to the same router.
Step4: Enter the user name and password of this camera to confirm the change, and exit “IPScan”. The default
user name and password are both “
admin
”.
Step5: Open the web browser, such as Internet Explorer, on your laptop / PC, and enter the IP address you just
set on the URL column to access this camera. The format is “http://ipaddress:portnum”.
In the login page, enter the user name, password, and security code to access.
Note:
Please skip the wizard.
Step6: Go to “Config.”
“DDNS”, and enable the DDNS service.
If your router supports UPnP, please proceed Step7.
If your router doesn’t support UPnP, note down the host name, such as
MAC000E5320E73E.ddns.eagleeyes.tw
,
and click “Save”. Then, access your wireless router for port forwarding as instructed in “APPENDIX 4 CONFIGURE PORT
FORWARDING” at page 19.