Installation
1.
Plug-in to your ATX power 24pin and plug-in (P4/P6/P8) into the
tester before turn on power
20pin ATX PSU:
recommend to use P4 connector
24pin ATX PSU:
recommend to use P6 connector
EPS PSU:
recommend to use PS connector
2.
Turn on the ATX power supply.
3.
LCD shows each voltage and P.G. value on the screen
automatically and you can hear 2 beep sounds.
4.
ATX power output connector checking one by one.
If power output is working, the LED will light on
If power output failed, the LED will not light on.
5.
Plug-in (HOD/Floppy y) connector and check LED light.
(+12 V1/+SV).
6.
Plug-in SATA connector and check LED light
(+12 V1/ +5V/+3.3V).
7.
Remove the connector after your checking.
8.
Do not plug-in 2 connectors into the tester at same time.
(Not include 24pin & (P4/P6/P8) connector).
9.
Abnormal voltage detected will not display on the screen.
10.
No voltage detect, "LL" will display on the screen.
11.
Detected Voltage lower than Min. value, "LL" will display on the
screen.
12.
Detected Voltage higher than Max. value, "HH" will display on
the screen.
13.
When detected voltage is lower than table value (A), will alarm.
14.
When detected voltage is higher than table value (B), will alarm.
15.
P.G. Value check table: (A)
