DS-51000-1
No IP Module Rear View
The part marked with “DS-55100-1” is the external baffle of the extended IP module,
and it needs to be removed and replaced to install the IP module.
INSTALLATION
Single KVM device installation
Note:
Before installation, make sure that the equipment is powered off. To prevent
damage to the equipment during installation, make sure that all the devices installed
are well grounded.
To install a single-level KVM, refer to the following online diagrams (numbered in the
order of steps on the online graph) and operate as per bellowing:
1.
Plug your USB keyboard, mouse, or PS/2 keyboard and mouse into the USB or
PS/2 console port on the rear of the switch.
2.
Connect the VGA monitor's video signal cable to the VGA console port and turn
on the power.
3.
Plug the VGA connector into the VGA port of any available VGA port on the
switch by using a set of KVM cables corresponding to the product model.
4.
Connect the corresponding VGA video connector, USB or PS/2 connector of the
KVM cable to the corresponding PC port.
5.
Plug the power adapter supplied with this package into the AC power supply,
and plugs the other end of the power adapter into the power jack on the
switch.
