©2010 Digitrax, Inc
www.digitrax.com
6
Function Outputs on the DN143IP
The DN143IP is set up at the factory to control four function outputs. The
DN143IP is configured to control the forward and reverse lights on the locomo-
tive through the plug using Function 0 (F0F-forward and F0R-reverse) for
directional lighting. Function F1(Green) and F2 (Violet) outputs are available
in the pad positions shown in figure 1. The wire colors indicated are the stan-
dard color code used in the industry. These colors are important if you plan to
use function remapping.
All four function outputs can be easily set up with Digitrax FX
3
lighting effects
or as standard on/off functions with the following operational qualifiers:
1. Forward or Reverse direction of travel, or
2. Whether F0 is on or off, or
3. Both direction of travel and whether F0 is on or off, or
4. Whether the locomotive is stopped or moving.
Programming Ditch Lights
To program your decoder for alternating ditch lights use the following CVs:
CV51 = 106, CV52 = 107, CV63 = 64. The ditch lights are wired to the F1 and
F2 outputs for this.
Function Remapping
Function remapping allows you to program the function outputs of your
decoder to be controlled by selected function keys on your throttle. Please
consult the Digitrax Decoder Manual or website for information on function
remapping.
Master Light Switch
Each of the four function outputs can be programmed to turn on and off with
the F0 ON/OFF key on your throttle, creating a Master Light Switch. The CV
values for creating this effect are listed in the Digitrax Decoder Manual in the
section:
Setting Up FX & FX
3
Effects on Function Outputs.
Complete Train Control
Run Your Trains, Not Your Track!
