DigiTech JamMan Express XT, Руководство пользователя

Страница: 12 / 18

6
Operation
The JamMan Express XT was designed to be very simple to use right out of the box� This
section of the manual describes how to perform the basic looping functions�
Recording a Phrase
The JamMan Express XT records a single phrase and then plays it back as a continuous loop�
To record a phrase:
1� Press the
FOOTSWITCH
and begin playing to start recording� The
REC LED
will light
solid red and recording will begin�
2� When finished recording, press the
FOOTSWITCH
once to set the loop end point� The
phrase will automatically begin playing back in a repeating loop and the
PLAY LED
will
light solid green�
3� Press the
FOOTSWITCH
2 times quickly to stop loop playback�
NOTE: The maximum phrase recording length is 10 minutes�
Clearing a Phrase
Clear a phrase to re-record it or record a new phrase� The JamMan Express XT has a
unique feature, referred to as "Silent Clear
™
", which clears a phrase without requiring you
to play it first� Note that you cannot undo the process of clearing a phrase, so make sure
you want to proceed before performing this function�
To clear a recorded phrase:
1� Stop loop playback if it is not already (all LEDs should be off)� If loop playback is active
(the
PLAY LED
is on), press the
FOOTSWITCH
2 times to stop loop playback�
2� Press and hold the
FOOTSWITCH
for ~2 seconds� The
REC LED
will quickly flash red,
indicating the phrase has been cleared�
NOTE: When using a slave/master looper setup, if the master loop is ~3 seconds or less
and if pressing and holding the
FOOTSWITCH
from a stopped state does not initiate
clear on the slave device, you may need to initiate play then stop (3
FOOTSWITCH
presses) and hold the footswitch on the 3rd press to clear its loop�