Page 7 of 11
INEAR User Guide
Charge operation :
When the INEAR is charging, the LED provides information about the state of charge.
Charging :
-Two flashing pulses each 2 seconds..
Charge 100% :
- The LED turns off completely.
Operation Flashing:
The LED will flash
:
- Quick flash
- Pause.
- Quick flash
The cycle will be repeated during 11 seconds.
By activating the "Find IE" menu of the BELTPACK, the LED indicates that the INEAR is
connected.
Power OFF Operation:
To turn off the INEAR, press the button for at least 2.5s.
The LED will flash
:
LED remains alight for 1 second and then it turns off..
Technical notes
- When a battery autonomy is low a beep sounds every minute in order to indicate the
low battery status of the INEAR. There is now only 15 minutes of autonomy left.
- A paired INEAR connects automatically to the BELTPACK if it is located within its range.
- The pairing procedure is explained in the BELTPACK user guide.
- In order to utilize the dual stream (see BELTPACK User Guide), a second INEAR must be
paired. The one that is already paired must be switched off. The second INEAR will then be
paired. Then the first INEAR can be re-turned on and both INEARs can be used in the dual
stream mode.
Alive Mode Operation:
If the INEAR is connected and turned on, then no light signal is visible.
In order to check the INEAR status, just press the button shortly. A quick flash will indicate
its operation status.
