Instructions
1. Verify all components included with the extender set are present before installation.
2. Turn off power and disconnect the audio/video equipment by following the
manufacturer’s instructions.
3. Connect solid core Category 6 F/UTP greater twisted pair cable with RJ45
connectors between the transmitter and the receiver. TIA/EIA-568B straight-through
wiring connections are recommended.
4. Connect a source such as a Blu-Ray Player, game console, A/V Receiver, Cable or
Satellite Receiver, etc. to the HDMI input on the Transmitter.
5. Connect a display such as an HDTV or HD Projector to the HDMI output on the
Receiver.
6. For power, plug both the Transmitter and Receiver unit with the included power
supplies to power the entire DL-HD50C circuit
7. IR in: Connect to the IR Receiver for IR signal reception. Ensure that remote being
used is within the direct line-of-sight of the IR receiver.
8. IR out: Connect the IR Blaster cable included in the package for IR signal transmission.
Pace the IR blaster in direct line-of-sight of the equipment to be controlled.
9. Power on attached audio/video devices.
10. EDID: The switcher can switch copy EDID function, switch to right position, the
extender will copy HDMI loop out display EDID information to source. Switch to left
position, the extender will copy Receiver display EDID to source.
TIA/EIA-568B
Orange/White
Orange
Green/White
Blue
Blue/White
Green
Brown/White
Brown
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
1
8
Twisted Pair Wiring
Use TIA/EIA-568B wiring for Category 6
connections between send and receive
units and when using the Ethernet
connections.
Important notice:
•
Do not attempt to disassemble or alter the extender housing. There are no user-
serviceable parts inside the unit. Doing so will void your warranty.
•
To minimize the possibility of equipment damage from electrostatic discharge
(ESD), all source and destination equipment must be powered off during installation.
•
Do not connect the extender to a telecommunication outlet wired to unrelated
equipment. Doing so may damage the unit or any connected equipment. Ensure all
connected twisted pair cabling is straight-through (point-to-point).
•
Allow proper ventilation to reduce the risk of thermal failure.
