1. Once all cables have been connected, use the screws included with the camera to properly mount and secure the camera to
the mounting surface.
2. Adjust the camera’s pan, tilt and position to achieve the desired view. The cameras’ max angles are:
Pan: 0° ~ 355°
Tilt: 0° ~ 70°
Rotation: 0° ~ 360°
3. The camera has a manual IR switch, located under the camera’s lens. You can use this
switch to manually turn the IR LEDs on or off according to your installation needs.
4. Once the installation is complete, remove the protective film from the camera’s dome cover.
To remove it, loosen the screw on the decorative ring and rotate the ring
counter-clockwise to remove.
Quick Start Guide
1. The camera supports HD-Analog, HD-CVI and HD-TVI signals. To
switch between the signals:
a. Enter the camera’s OSD menu. You can access it locally from
using the camera’s joystick in the body of the camera, or from a
recorder supporting UTC communication. Go to SETUP >
OUTPUT > ANALOG MODE.
b. Set the camera’s analog signal output from the following
options:
• HD-A: supports 5MP/1944p @ 20fps and 12.5fps, 4MP/1440p
@ 30fps, 2.1MP/1080p @ 30fps and 720p @ 30fps.
• HD-T: supports 5MP/1944p @ 20fps, 4MP/1440p @ 30fps,
2.1MP/1080p @ 30fps and 720p @ 30fps.
• HD-C: supports 4MP/1440p @ 30fps, 2.1MP/1080p @ 30fps
and 720p @ 30fps.
• CVBS: supports up to 960H @ 30fps
c. Change CONFIRM to ON to save the changes.
d. Go to the EXIT menu and select SAVE&EXIT to save all changes.
The camera signal automatically.
STEP 4 – INSTALLING THE CAMERA
STEP 3 – CHANGING THE SIGNAL IN
THE CAMERA
Rev Date: 06/19
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
Template
Sheet
IR Switch
ON/OFF
Rotation 360°
Titling 70°
Panning 355°