33
Setup - Network Setup
Network Settings
1
Network Type -
Define network IP address type from the Static Mode for the fixed IP or the Dynamic Mode by the dynamic
IP address.
If you select the Static Mode, you must fill out IP Address, Subnet Mask, Gateway, DNS Server, and all ports.
If you select the Dynamic Mode, the IP address will be allocated automatically by DHCP equipment.
If you click the Apply button to update changes, the system will be re-booted.
In this case, you have to reconnect the camera using new a IP address.
2
IP Address -
Define the IP address. The address consists of four numbers separated by dots and the range of each number is
from 0 to 255.
3
Subnet Mask -
Define the Subnet Mask. The format is the same as the IP address.
4
Default Gateway -
Default the Gateway IP Address. The format is the same as the IP address.
5
Preferred DNS Server -
Define the DNS server IP address. The format is the same as the IP address.
6
Alternate DNS Server -
Define the Secondary DNS server IP address. The format is the same as the IP address.
7
HTTP Port -
The HTTP port can be set to the default 80 port, or any value in between 1025 to 60000.
8
HTTPS Port -
The HTTPS port can be set to the default 443 port, or any value in between 1025 to 60000.
9
RTSP Port -
The RTSP port can be set to the default 554 port, or any value in between 1025 to 60000.
10
Click ‘Apply’ to save all settings.
If the network type is dynamic, the IP address is changed in the following cases. In these cases, the IP address needs to be searched again,
and the camera needs to be reconnected:
- When the camera's power is switched off and on.
- After firmware update, or when the camera is reset to its default settings and reboot.
1
2
3
4
7
5
8
6
9
10