DWC-MB72I4V
Step 1 – PREPARING TO MOUNT THE CAMERA
Step 3 – INSTALLING THE CAMERA
Step 2 – CABLING THE CAMERA TO EXTERNAL
DEVICES
1.
The mounting surface must bear five times the weight of your
camera.
2.
Do not let the cables get caught in improper places or the electric
line cover to be damaged. This may cause a breakdown or fire.
3.
Using the mounting template sheet or the camera itself, mark and
drill the necessary holes in the wall or ceiling.
5.
To use the camera’s water proof wiring:
(1).
Install the LAN cable into (a).
(2).
(b) will be assembled to (a) with a 1/4 turn.
(3).
Thread (c) tightly to (b).
6.
Before mounting the camera, loosen the pan/tilt screw on the side
of the camera’s bracket. This will make adjustment after mounting
the camera easier.
7.
Fix the camera on to the mounting surface using the screws
included with the camera.
8.
Adjust the camera’s pan and tilt. Tighten the pan/tilt screw on the
camera’s bracket until it is secured properly.
4.
Pass the wires through the mount bracket and make all necessary
connections.
a.
NETWORK CONNECTIONS – If you are using a PoE Switch,
connect the camera using an Ethernet cable for both data and
power.
b.
NETWORK CONNECTIONS – If you are using a non-PoE
switch, connect the camera to the switch using an Ethernet
cable for data transmission and use a power adapter to power
the camera.
NETWORK
CONNECTION
POWER
1
2
3
Template
Sheet
Quick Start Guide
Quick Start Guide
Username:
admin
Password:
admin
Attention: This document is intended to serve as a quick reference page for
initial set-up. It is recommended that the user read the entire instruction
manual for complete and proper camera usage.
Tel: 866-446-3595 / 813-888-9555
Technical Support Hours:
9:00AM – 8:00PM EST, Monday thru Friday
digital-watchdog.com
WHAT’S IN THE BOX
QSG Manual
1 Set
Manual CD
1 Set
Template Sheet
1 Set
Screw & Plastic Anchor – 4pcs
1 Set
Torx Wrench
1 Set
Note: To ensure moisture seal, make sure the o-ring is in place
between (a) and (b). In extreme environments use of an
outdoor rated sealer is recommended.
Resetting the camera:
To reset the camera, use the tip of
a paper clip or a pencil and press the reset button. Pressing
the button for five (5) seconds will initiate a camera-wide reset
of all the settings, including network settings.
a
b
c
Pan/Tilt
Screw
8
Power Requirements
Power Consumption
DC 12V
PoE IEEE 802. / PoE Class 2
LED Off: 1.92W, 160mA
LED On: 2.7W, 230mA (IR models only)
Reset
Button