11
1
Power Connection
Please, check the voltage and current capacity of
rated power carefully.
2
Network Connection
Connect the crossover cable into the RJ-45.
Installation -
Cabling
1
Power
2
Network
4
Audio Output
3
Audio Input
5
Alarm Output
6
Alarm Input
6
Alarm In
5
Alarm Out
Rate Power
Power
Consumption
PoE
DC 12V
9W
IEEE 802.3af
class3, max
10.5W
DI
DOT
DI COM
YELLOW
DO1
COM
BLUE
DO1
(N.O.)
BLUE + DOT
N.C
N.O
In 1
COM
In 1
COM
In 1
COM
In 1
COM
3
Audio Output
Connect the ‘audio out’ port of the camera to the
‘line in’ port of the speaker.
If the speaker without the amplifier is connected
to the audio out port, it doesn’t work properly.
Therefore, the speaker with the amplifier or the
separate amplifier is needed.
Audio Out is available via the RTSP backchannel.
4
Audio Input
Connect the ‘audio in’ port of the camera to the
microphone directly or 'line out’ port of the
amplifier connected with a microphone.
If the microphone is connected directly, the
microphone with the embedded amplifier such
as condenser mic. needs to be used.
5
Alarm/Relay Out (DO)
Connects to the alarm lights, siren or lamps and
the sensor types are normally open and
normally close.
6
Sensor/Alarm Input (DI)
The sensor/alarm input device's cable should
connect to + and - of the Terminal Block.