Digital View M3-310, Руководство пользователя

Страница: 13 / 36

Page 13 of 36
5.1 Jumpers setting
Ref Purpose Note
JA1 For internal testing 1-3 & 2-4 closed, factory set, do not remove
JA3 Panel power voltage select See panel voltage setting table 1
CAUTION: Incorrect setting will cause panel
damage
JB1 Backlight brightness voltage range 1-2 closed = 3.3V max*
2-3 closed = 5V max
JB2 Backlight inverter on/off control – signal
level 2-3 = On/Off control signal „High‟ = +5V*
1-2 = On/Off control signal „High‟ = +3.3V
Open = On/Off control signal „High‟ = Open
collector
CAUTION : Incorrect setting can damage
inverter.
JB3 Backlight inverter on/off control – polarity 1-2 = control signal „high‟ = CCFT ON*
2-3 = control signal „low‟ = CCFT ON
JB5 Backlight control type selection 1-2 =VR/Digital switch mount control
3-4 =Reserved
5-6 =Reserved
JB6 Backlight status 1-2, 3-4 closed = Backlight status Low –
Normal
1-3, 2-4 closed = Backlight status High –
Normal
Open = Backlight status not used
JP1 Reserved Reserved for internal programming use (Always
1-2 closed)
JP2 Panel selection See table 3 below
JP3 Panel selection See table 3 below
JP4 Detect the watchdog pulse 1-2 closed =Off the detection*
1-2 opened=On the detection
JP5 Panel selection See table 2 below
JP6 Input power control Short = External switch control
Open = Switch mount control
JP7 Panel selection See table 4 below
* Factory default
Table 1: Panel voltage setting
Input voltage via
PP1
Panel Voltage JA3
Jumper on
board
12VDC
3.3V 3V3 closed
5V 5V closed
CAUTION: Incorrect setting can damage the panel & controller