8-18
Disabling the Cabinet Buttons [Control Panel Key Lock]
This option turns on or off the Control Panel Key Lock function.
NOTE:
* This Control Panel Key Lock does not affect the remote control functions.
* When the cabinet buttons are disabled, pressing and holding the CANCEL button
for about 10 seconds will change the setting to enable.
Lamp Settings
The projector is designed to accept two lamps (dual lamp sys-
tem). This dual lamp system provides prolong lamp life or high
brightness or extra lamp (Long Life lamp 160W).
NOTE: Be sure to use the same lamp type for both lamp 1 and 2.
Lamp Mode
This feature enables you to select two modes of the lamp:
Normal and Eco. The lamp life can be extended by using the
Eco mode.
Normal Mode . This is the default setting (100% Brightness).
Eco Mode .... Select this mode to increase the lamp life (80%
Brightness).
NOTE: When the optional Long Life lamp is used, the Lamp Mode is fixed to Eco
mode.
Lamp Select
This feature allows you to select which lamp to be used.
NOTE: This option is not displayed in the Basic menu.
*
Changes to these options will not take effect for 90 seconds imme-
diately after the lamp is turned off (120 seconds for the extended
life lamp).
*
The lamp cannot be turned off for 60 seconds immediately after
the lamp is turned on. Changes to these options cannot take effect
until then.
Dual ............. Select to use the two lamps at the same time to
increase brightness.
Lamp1/2 ...... Select to use one lamp of the two lamps. (Lamp
1 on the right side and Lamp 2 on the left side
when viewed from the front)
Interval
This allows you to specify the time for switching between the
two lamps alternately. This option is available only when
“Lamp1” or “Lamp2” is selected. When Auto is selected and
one lamp has reached the end of its usable life, the other lamp
is turned on. The lamp cannot be turned off for 60 seconds
immediately after the lamp is turned on.
NOTE: This option is not displayed in the Basic menu.
Lamp Type:
The lamp type you use and its information are displayed here.
The information displayed here are:
Light on or off, standard lamp or extended life (Long Life) lamp
and remaining hours.
Link Mode
Settings
Selecting Standalone/Master/Slave
This feature is used for multiple projector connection. The
master projector is set to Master. The other slave projectors
are set to Slave. When not using Link mode, set to Standalone.
See page 7-5 for setting up for double stacking in link mode.
Selecting Communication Speed [Communication Speed]
This feature sets the baud rate of the PC CONTROL port (D-
Sub 9 Pin). This is the same procedure as in “Page 6” of “Setup”.
Enabling and Disabling Projector ID:
Each projector needs its own unique addresses when used in
serial communication mode. This is the same procedure as in
“Page 6” of “Setup”.
Copying Signals in the Entry List
Press the Entry List Copy button to copy all of the signals re-
corded in the Entry List from one projector to another.
8. Using On-Screen Menu
Содержание SHOWlite 6000gv
Страница 1: ...SHOWlite 6000gv 5000sx LCD Projector User s Manual...
Страница 58: ...6 10 6 Using the Projector in a Network...
