Digital Projection INSIGHT 4K Dual LED Series, Инструкция по установке и быстрому запуску

Страница: 18 / 100

page 10
Digital Projection INSIGHT 4K Laser Series
Installation and Quick-Start Guide
FITTING THE LENS
Rev C June 2016
Fitting The Lens
1. Insert the lens into the mount.
Engage the three locating studs
1
into
the corresponding slots
2
on the mount.
2. Rotate the lens clockwise until the studs
slide all the way into the slots.
3. Tighten the two fixing screws
3
on the
lens collar.
1 2
3
Notes
This procedure applies to version
C of the projector. If your projector
is an earlier version or if you are
unsure which version you have,
see Appendix G in the Reference
Guide .
Before changing the lens,
always make sure the projector
is switched off and fully
disconnected from its power
supply.
When changing the lens, avoid
using excessive force as this may
damage the equipment.
Take care to preserve the original
lens packaging and protective caps
for future use.
The projector will not power on
without the lens fitted.
Before turning on the projector,
please ensure the protective caps
are removed from the front and rear
of the lens.
The two fixing screws must be
tightened to at least a torque
of 0.5 N-m using a screwdriver.
Loose screws might lead to the
lens falling off.
When a new lens is fitted, a
calibration procedure must be
carried out. For more information,
see
Calibrating zoom and focus
further in this guide.