Digital Projection HIGlite 8000 Series, Руководство пользователя

Страница: 41 / 84

Digital Projection
HIGHlite 8000 Series
CHANGING A LAMP MODULE Maintenance Guide
35 Rev F July 2014
Changing A Lamp Module
1. Turn the power OFF and allow the lamp to cool for 5
minutes.
2. Unscrew the two screws securing the lamp door, and
hinge the door down.
3. Unscrew the two crosshead screws securing the lamp
module to the projector.
4. Lift the wire handle up and use it to pull out the lamp
module.
5. Fit a new lamp module, pushing it firmly into place.
6. Tighten the two cross-head screws.
7. Hinge the lamp door back into the closed position.
Tighten the two retaining screws.
Notes
Always allow the lamp to cool for
5 minutes before:
- disconnecting the power
- moving the projector
- changing a lamp module
There are no user-serviceable
parts inside the lamp module.
Replace the whole module.
Use only lamps supplied by
Digital Projection and intended
for this projector. Fitting any
other lamp could damage both
projector and lamp, and will
invalidate the warranty.
At the end of a lamp life the lamp will
not strike and the ERROR indicator
on the control panel will flash red.
(Typical lamp life is 2000 hours.)
Do not use the lamp for more than
2000 hours as this may cause
serious lamp failure, damage the
lamp module and cause extra
cost on replacement.
Take care not to touch the glass
surface of the lamp module. If
you touch the glass, it should be
cleaned before use.
HID lamps produce high intensity
light. Do not look directly at
the light coming from the lamp
housing or the lens.
Opening the lamp door will switch
the projector OFF. The projector
cannot be operated until the door is
fully closed.