Digital Monitoring Products XR150FC, Руководство пользователя, Страница: 11 / 40

Introduction XR150FC/XR550FC User’s Guide 7
FAILED To EXIT (ANTI-PASS BACK) (Burglary Keypad)
Anti-passback requires users to properly exit (egress) an area they
have previously accessed. If they fail to exit through the proper
card reader location they are not granted access on their next
attempt. A Failed to Exit message appears when a user assigned the
anti-passback option attempts to re-enter an area which they did
not exit properly. The user must exit the area through the proper
door. If not possible, your system administrator should select the
Forgive option in the User Codes menu option.
SYSTEM TRoUBLE or SERVICE REQUIRED
There is a problem with one or more of the components in your
system. Contact our service department as soon as possible.
SYSTEM BUSY
The system is performing another task of a higher priority. This
usually only takes a few moments.
Special Fire Command Center Tones
Your keypad also contains a small speaker that alerts you about
events as they occur on your system. For an alarm, as soon as the
first digit key is pressed to enter a user code, the tone stops. If
no other keys are pressed for five seconds or an invalid code is
entered, the tone turns on again.
Fire Alarm tone
: An intermittent sweeping siren that sounds until
the fire alarm is silenced.
Key press tone
: A short beep each time you press a key on the
keypad and it is acknowledged by the system.
Prewarn tone : A continuous pulsed tone that sounds when you
open an entry delay door on a system that is armed (turned on)
reminding you to disarm the protection. The tone silences as soon
as the first user code digit key is pressed.
Exit tone
: A continuous pulsing tone that sounds during the exit
countdown just after arming to remind you to exit the premise. At
ten seconds prior to the end of the countdown, the rate of pulsing
increases.
Trouble tone
: A steady tone indicating a trouble condition on your
system. Press a Select key to silence.
What to do when the trouble tone sounds
You can silence the trouble tone by pressing any key.
This only silences the keypad and does not correct the
condition that originally caused the trouble.