Digital Monitoring Products GRAPHIC TOUCHSCREEN KEYPAD, Руководство пользователя

Страница: 14 / 25

Arming and Disarming Graphic Touchscreen Keypad User’s Guide 11
For an Area System the Keypad screen displays
SYSTEM ON
if
at least one area in the system is armed, followed by the area
numbers that were armed. The Keypad screen displays ALL SYSTEM
ON
if all areas in the system are armed.
Exit Delay:
The screen then displays the exit delay time as it counts
down. If the entire system has been armed, your system beeps the
exit delay tone at eight-second intervals until the last 10 seconds
when the keypad beeps at three second intervals. After exiting the
building, if you re-enter during the countdown the exit countdown
restarts, allowing additional time to then disarm or again exit the
building during the countdown. This restart can occur only one
time. When the exit delay time expires, zones are armed. If your
system uses a keyswitch to arm an area, the exit delay time does
NOT count down on the screen display.
When you arm both the
Perimeter
and
Interior
to leave the
building but then you do not exit by the time the exit delay ends,
the system automatically arms but the interior area(s) remain
disarmed because you have not exited.
I
nstant:
During the exit delay time, you can cancel the exit
and entry delays and cause all zones to be instant zones.
Press
ARM INSTANT
while the exit delay displays. This immediately
arms the exit zones. However, no entry delay is provided and an
alarm immediately occurs should an entry door be opened.
ONE MOMENT . . . Message: If your system is monitored, it may
be programmed to wait for the arming report to be sent to the
monitoring station before displaying the armed message. This
verifies that the arming message was received by your monitoring
station. While the system waits, the screen displays
ONE MOMENT....
When the report is received, the keypad buzzes for one second
and displays the armed message. If the report is not received, the
screen displays
LOCAL ALARM ONLY
before displaying the armed
message.
Key Fob Arming
Press the key fob button programmed for
Arming
or
Toggle (Arm/
Disarm)
button. A
Red LED
two-second acknowledgement indicates
All System On . A Green/Red two second acknowledgement
indicates
System On
with some areas armed.
Key Fob Disarming
Press the key fob button programmed for
Disarming
or
Toggle
(Arm/Disarm)
button. A
Green LED
two-second acknowledgement
indicates All System Off .