INSTALLATION GUIDE
1100DI Wireless Receiver
Description
The 1100DI Wireless Receiver provides up to 16 wireless zones for XRSuper6 and XR20 Command Processor™ panels
and up to 32 wireless zones (28 zones using one keypad) for XR40 Command Processor™ panels. The 1100DI is
compatible with all DMP wireless devices. The 1100DI provides two-way, supervised communication using 900 MHz
frequency hopping-spread-spectrum technology. The receiver can be installed anywhere on the panel keypad bus.
What is Included
The 1100DI Wireless Receiver includes the following items:
• One Model 1100DI Wireless Receiver
• One 4-wire Harness
• Hardware pack
Compatibility
The 1100DI Wireless Receiver is compatible with any XRSuper6, XR20, or XR40 Command Processor™ panels using
firmware Version 300 or higher. In addition to firmware Version 300 or higher, XR20 Command Processor™ panels
need to be hardware Level L or higher released October 2000. No specific receiver programming is required. Once
installed, a panel programmed with wireless information will automatically recognize the wireless receiver.
Installing the 1100DI Wireless Receiver
The 1100DI Wireless Receiver can be mounted anywhere along the panel keypad bus. A location should be selected
that will be centrally located between the 1100 Series transmitters used in the installation. Install the receiver
away from large metal objects. Mounting the receiver on or near metal surfaces impairs performance. Do not used
shielded wire between the panel and receiver. When selecting the proper mounting location and operation, refer to
the LED Survey Operation section of the specific installation guide for the transmitter being installed.
Figure 1: Receiver PCB
Installing the Receiver behind a Keypad
The following instructions cover installing the receiver inside the wall behind the keypad. If the installation requires
the receiver to be mounted, refer to Installing the Optional Mounting Bracket or Installing the Receiver without the
Mounting Bracket.
1. Remove the cover from the plastic housing by squeezing both sides toward each other.
2. Connect the receiver to the panel keypad bus using the supplied 4-wire harness. Route the wires through the
opening in the back of the housing.
3. Snap the cover back in place and suspend the receiver inside the wall behind the keypad. Do not install the
receiver inside of a gang box.
Keypad Bus
header
Wire
opening
