Digital Identification Solutions XID 8300, Инструкция по эксплуатации

Страница: 50 / 64

Error Code Jam(Retran.) 95
v
Card jam near the retransfer heating roller.
.
1
Open the printer door
v
A [Please Remove Jam Card!] or [Please Close Door] message
appears.
2
Pull out the retransfer film cassette
.
Cautions:
v
The card may be adhered to the retransfer film. Pull out the
retransfer film while taking care not to jam it.
v
If a [Please Close Door] message is displayed, the retransfer film is
stuck and the retransfer film cassette cannot be removed.
In this case, close the printer door before pulling out the retransfer
film cassette.
3
Remove the jammed card
"If the card is adhered to the retransfer film" (
A
page 50)
"If the card is inside the printer unit" (
A
page 51)
"If the card is caught in the card feed roller to the right of the retransfer
heating roller" (
A
page 51)
"If the card is caught in the card feed roller to the left of the retransfer
heating roller" (
A
page 52)
4
Install the retransfer film cassette, and close the printer door
5
Press K
v
A [Jam Card Removed?] message appears.
.
6
Press
O
Cautions:
v
Initializing the printer without first removing the card will cause the
printer to malfunction. Be sure to remove the card then press
O .
v
An [Initializing..] message appears, and initialization of the printer
starts.
.
m
If the card is adhered to the retransfer film
v
Remove the jammed card with a hand.
.
Cautions:
v
The card may be very hot. Be careful not to burn your fingers
when removing the card.
"Go to step 4" (
A
page 50)
Troubleshooting
50