Note
The following available tests are not used on the MicroVAX 3100
Model 90; they are used only on the MicroVAX 4000 Model 100A, and
are listed here to avoid confusion when you see them in the diagnostic
test listing (Figure 1–2).
Table 1–3 MicroVAX 4000-100A Tests
Test
No.
Name
Usage
56
SHAC_LPBCK
Not used on 3100, SHAC option only
58
SHAC_RESET
Not used on 3100, SHAC option only
5C
SHAC
Not used on 3100, SHAC option only
62
console_QDSS
Not used on 3100, QBUS systems only
63
QDSS_any
Not used on 3100, QBUS systems only
81
Qbus_MSCP
Not used on 3100, QBUS systems only
82
Qbus_DELQA
Not used on 3100, QBUS systems only
83
QZA_Intlpbck1
Not used on 3100, QBUS systems only
84
QZA_Intlpbck2
Not used on 3100, QBUS systems only
85
QZA_memory
Not used on 3100, QBUS systems only
86
QZA_DMA
Not used on 3100, QBUS systems only
To run the diagnostic tests, enter either TEST or T followed by the test number.
You can specify optional parameters for some tests, but you would not do so
normally. If you decide to specify optional parameters, then the following
conditions apply:
• Each test uses up to 10 parameters, no more than 7 may be inputted on
command line.
Most of these parameters are assigned values automatically by the system.
These parameters are indicated by an asterisk (*) in the parameters
column of Figure 1–2.
• If a parameter can be assigned a value, the name of the parameter is
shown in the parameters column in Figure 1–2.
1–16 Troubleshooting and Diagnosing Problems
