4. Connect the System Unit Cables
As part of your system installation, you must attach
cables, cords, or terminators to the back of the sys-
tem unit, as follows:
1. Connect a SCSI terminator to the SCSI port,
labeled in panel 3, when the port is not in
use.
If you have a SCSI peripheral device, remove
the terminator from the system unit and connect
the device to this port using a SCSI cable.
2. Connect the keyboard/mouse extension cable to
the keyboard/mouse port, labeled in panel 3.
3. Connect the video cable for your monitor to the
monitor video port, labeled in panel 3.
4. Connect the power cord for your monitor to the
monitor power socket, labeled in panel 3.
This cord has recessed prongs on the end that
connects into this socket.
5. Connect the power cord for your system unit to
the system power connector, labeled in
panel 3. This cord is the one that you will con-
nect to a wall power outlet.
Note: If there is a yellow sticker over the power
connector, your system has factory-installed soft-
ware. You must remove the sticker prior to installa-
tion of the power cord.
.
3
8
10
11
12
