8
From left to right:
LAN
: You can connect the Ethernet port to PC or the other switch.
POWER
: Please supply the power in 12V and 1A.
Reset Button
: Press Reset button to revert it to factory default.
Antenna port
: There are two antenna ports in the both ends of this side. Connect the
antenna into the port.
Hardware Installation
Once you check everything from the package, you can start to install the device. You can
use the wall mount hole on the bottom of the device to mount the device on the wall, or
just put the device on the desktop. The administrator can refer to the figure below while in
the process of constructing your WLAN environment.
Ch 2. First Time Configuration
Before Start to Configure
The configuration of this device is through web-browser. To access the configuration
interfaces, make sure you are using a computer connected to the same network as the
