Digital Control Systems AirSense 310en, Руководство оператора

Страница: 8 / 19

AirSense Model 310en Operator’s Manual
Wiring
This section describes the external connections to the Model
310en. Figure 2 shows the location of the components
described in the following sections.
UP
button
User
Jumpers
Shorting block here
for current output.
Shorting block here
for voltage output.
Analog Output Selector
DOWN
button
Analog
Output
Upper Mountinhg
Screw Access
Wiring Access
+
-
C DCS 2010
32-0310-30
4-20mA
OUT
RLY
POWER
V
I
DN
-
+
0-10V
UP
SEL
SW3
J4
SW1
SW2
JP4
JP1
JP3
JP5
JP2
Lower Mounting
Screw Access
Calibration Nipple
(Under sensor
electronics)
C
O
2 SEN
SO
R
Power In
20 - 28 VAC
18 - 30 VDC
(Polarity matters
for DC only)
Optional
Relay Contact
Output
Figure 2: Model 310en Component Locations
Power Supply
The Model 310en is not a loop powered device
The Model 310en will operate from an AC or DC input
voltage between the values called out in the specifications on
page 3. The power supply leads are connected to the two-
terminal power connector. shown in Figure 2.
The Model 310en must never be connected directly to
line power.
Operation at voltages higher than specified will
damage the unit and void the warranty.
When operating from DC power, the polarity of the power
leads must be as shown in Figure 2. Reversed polarity
3/9/15
Digital Control Systems
Page:
5
www.dcs-inc.net
•
503/246-8110