20
The ProTools Mix 24 compatible I/O’s.
1.
If a ProTools compatible interface is mounted in the ADDA 2408 you can connect this interface on the
ADDA 2408 directly to the computer, the same way you normally connect your 888/24 I/O's.
2.
Turn on the power on the ADDA 2408. Then start the ProTools system.
3.
In the Hardware set-up menu of the ProTools system the ADDA 2408 is showing itself as an 888 /24
interface, and has to be set up as an 888 /24 interface. However the ADDA 2408 (888 /24 ) has to be set
to internal sync in the ProTools menu. At the ADDA 2408 the ProTools interface will be identified as multi
1 or multi 2.
4.
The sync source for the ADDA 2408 must be chosen on the front panel of the ADDA 2408.
5.
Generally we recommend the ADDA 2408 as the master clock generator, because of its much more
accurate oscillators (5ppm) compared to most units.
6.
We also recommend Word Clock instead of Super Clock where possible, because Super Clock is 256
times faster than Word Clock and therefore more sensitive to Jitter.
7.
On the ProTools Mix 24 compatible interface you will also find two BNC connectors called ‘In’ and ‘Out’.
These connectors are for Super Clock in/out. If you want to synchronize the ADDA 2408 via Super
Clock, connect a valid Super Clock signal to In and choose Super Clock at the Sync button on the front
panel. If you want to synchronize an 888 I/O or USD from the ADDA 2408, connect the Super Clock
input on one of these units to the Super Clock out at the ProTools Mix 24 compatible interface mounted
in the ADDA 2408.
.
