THREAD
MOUNT
The mic stand thread mount configuration allows a CS-
DUO or CS-SOLO to mount on a dedicated microphone
stand. This mounting method is perfect for musicians that
don’t require other stands for microphones or music.
Four captive thread holes on the bottom side of the
CS-DUO or CS-SOLO allow the personal mixer to mount
in two different positions on the MT-1.
Before you begin, locate these parts of the MT-1:
1. Large circle opening on the bottom side of the
mount
2. 1x 5/8” - 27 nut (secured to MT-1 with V-Clamp
screw.
3. 2x Captive thumbscrews (thread into personal
mixer)
To attach the MT-1 and CS-DUO or CS-SOLO to
your mic stand:
1. Align the large circle opening on the bottom side of the
MT-1 with the top of the microphone stand.
2. Secure the MT-1 by threading the 5/8” - 27 nut until it is
finger tight.
3. To firmly lock the MT-1 in place, hold the microphone
stand pole with one hand while turning the MT-1 with the
other hand.
4. Locate the two captive thread holes on the bottom side
of the personal mixer that are closest to the front panel.
These are the recommended mounting connections on
the CS-DUO or CS-SOLO for this configuration.
5. While holding the CS-DUO or CS-SOLO, align the MT-1
captive thumbscrews with the personal mixer captive
thread holes mentioned in step 4.
6. Still holding the personal mixer, thread the thumbscrews
into the mixer by hand. If permanent attachment is desired, the thumbscrews can also
accommodate Flathead and Phillips screwdrivers.
7. Route cables through cable management openings.
1266 Park Road
Chanhassen, MN 55317
952-401-7700
www.digitalaudio.com
