DVM-500Plus Installation Guide 002-0501-02 REV C
Page 15
Rear Camera (optional)
Determine a mounting location for the auxiliary rear camera. Digital Ally suggests securing the camera
in the center of the cage along the roofline
or on the driver’s side hanger hook. This gives a wide
angle view of the entire back seat. Route the remaining portion of the camera cable to the external
surface mount camera and connect. Secure extra cable in the headliner away from any other existing
cabling and/or airbag.
The external Rear Microphone cable should be routed to the rear of the vehicle and is usually placed covertly
on the roofline door seal near the cage.
Rear Microphone
The magnetic GPS antenna/receiver can be placed in the corner on the front or
rear dash of the vehicle, or mounted externally if desired. Use high quality
Velcro or double-sided tape if mounting internally. Connect the GPS antenna
cable to the GPS INPUT connector on the back of the DVM system. Optionally,
the magnetic antenna/receiver can be mounted on the outside of the vehicle if
better reception is required.
GPS antenna
Connect the
power and sensor input wiring harness
(11-wire, 14-pin,
multicolored) to the interface box and follow the wiring chart on page 16
to connect the desired optional inputs and record triggers. Insert the
two 7.5 AMP fuses into the slots located on the side of the interface
box, as shown in the picture to the right.
I
t is recommended that these connections are made directly to the police
package accessory harness or engine compartment battery wiring harness for best results. These wires should be used
ONLY for the DVM system and not be tapped into for installation of any other equipment in the vehicle. Doing so, could
result in possible radio frequency interference from the other equipment.
NEVER connect Digital Ally equipment
through a vehicle charge guard or battery saver.
Step 6:
GPS and Rear Microphone Connections
Step 7:
Power Ignition, Ground, and Trigger Connections
(2) 7.5A fuses
