DIGISYSTEM LABORATORY INSTRUMENTS INC.
Instruction Manual for Digital Micro Centrifuge DSC-103SD with rotor MAR-24
Control panel
Warnings:
* Do not open the lid before the centrifuge stops completely.
* Do not remove the centrifuge during operation.
* Do not put objects on the top of the lid.
* Do not disassemble the centrifuge by yourself. In the event of a malfunction, the centrifuge should be
repaired by a qualified technician. Before repairing, turn off the power.
Steps:
1.
Place the centrifuge on a flat surface. Plug the centrifuge into a properly grounded outlet. Turn on the
power switch. The power indicator on the switch is illuminated.
2.
Push the button , and then the screen is illuminated. Press the button to open the lid. The
screen shows icon
“
door
”
.
3.
Use your two fingers to hold the “Rotor cover head” as shown in” Figure 1” and use
your thumb to press down on the center of “Rotor cover head”, and then lift the
cover. Set an even number of test tubes into the rotor in a symmetrical position.
4.
Put down and press down the lid. Make sure the lid is closed well. The icon
“
door
”
will disappear on the screen.
5.
Push the button , the speed value is flash one the screen. Push the button or or
Lid
Emergency bar
Power switch
Figure 1
Rotor cover head
for Rotor MAR-24
Rotor MAR-24
