Digimerge DND7220 Series, Быстрое руководство по установке

Страница: 5 / 20

DND70 Series_Quick Installation Guide_En_R1
w w w
.
d i g i m e r g e
.
c o m
Page
Hardware Installation - Connecting the Cable
The Camera has a single cable, which splits into
several different connection ports:
1. Ethernet : Connect an Ethernet Cable to the
RJ-45 Ethernet port to connect the Camera to
the network.
• The Red PWR LED indicates the Power state
of the Camera (ON/OFF).
• The Green NET LED indicates the Network
state of the Camera. The LED will blink when
network communication occurs.
2. BNC: Connect a BNC Cable to view the Camera
on a CCTV Monitor or DVR with analog
(non-IP)Video inputs. This is an optional
connection.
3. Audio: Connect an RCA Cable to the audio
port on a CCTV Monitor or DVR (when using a
BNC Video Connection) to listen to Audio from
the camera. This is an optional connection.
4. Alarm Block: The Camera Alarm Block can be
used to send or receive a signal from a
compatible DVR or CCTV System. Please
consult the manual for the device you wish to
connect to the camera for details.
i. Use a small screwdriver to loosen the selected
screws.
ii. Insert the cables for the Alarm, NO, COM or
GND (as needed)
iii. Use the screwdriver to tighten the screws to
hold the cables in place.
5. Power Adaptor: Connect one end of the Power
Adaptor to the camera once all other
connections have been made. Connect the
other end to a compatible power source.
HARDWARE CONNECTIONS
1
C
1
Continued
2
3
4
4i 4ii