SYSTEM CONTROLLER
Junction Box
RJ-11 Cable
⑥
⑤
④
③
②
①
⑦
Slave Port Master Port
< Configuration of Junction Box >
① RS-485 (+) :Connect to PTZ (+)
② RS-485 (-) : Connect to PTZ(-)
③ Power input : DC12V (-)
④ Not used
⑤ Not used
⑥ Power input : DC12V (+)
⑦ RJ-11 Modular Jack : Connect to Controller
- 5 -
UNPACKING
Unpack the equipment and make sure all listed items are included in the box.
Product Carton 1
Keyboard controller ………………………………………………….……… 1
Junction box ………………………………………………………….………. 2
3m 6p cable RJ-11………………………………………………….………… 2
Instruction manual ….………….…………………………………………….. 1
Product Carton 2
12V DC Power Adaptor
.……………………………………………………………. 1
1. CONNECTIONS
There are two connectors on the controller. These connectors are RJ connector for Master and
Slave control.
1.1 Open the junction box cover and connect the 12VDC power to the junction box number 3 and 6.
1.2 Connect 6-pin multi-wired cable between junction-box and keyboard.
1.3 Connect PTZ communication wires (RS-485, 2-wires) to the junction box number of 1 and 2.
1.4 Turn on the power , then you will get into the starting mode.
Installation
