Focus 48 - LED Lighting Profile
Installation Guide
digilin.com.au
+617 3899 1267
Page 2 of 3
Installation
1.
If necessary, assemble full length before
install. For interconnections follow the
“
Extrusion interconnects
” guide before
moving to next step.
2.
Cut a hole in the ceiling to the cut-out size
3.
With mains circuit off, connect driver to
mains.
4.
Connect lead from driver to luminaire and
place driver in ceiling. Power can now be
turned on to test the fitting if desired.
5.
Squeeze the support springs above the
fitting and insert fitting into cut-out.
6.
Gently release the springs and allow them to
pull the fitting into place. If nessecary
gently push the unit upwards to assist..
7.
Power on fitting.
Note: Drivers should not be covered. Drivers rely on convection air flow for cooling and covering them may cause them to enter thermal regulation.
For any technical information relating to the connection of these luminaires to dimming systems, refer to LED products at
