Calibre - Linear Flood
Installation Guide
digilin.com.au
+617 3899 1267
Page 3 of 3
Installation
1.
Loosen the grub screw holding the 2
mounting brackets in place.
2.
Slide the mounting brackets into the desired
location
3.
Secure the fitting to the mounting surface
using suitable fasteners.
4.
Lock the mounting brackets back into place
by tightening the grub screws.
5.
Adjust the fitting angle as required.
6.
Lock the fitting angle by tightening the
screws on the mounting bracket.
7.
Connect power (and data) using a suitable
waterproof connection method.
8.
Apply power
Note: Drivers should not be covered. Drivers rely on convection air flow for cooling and covering them may cause them to enter thermal regulation.
For any technical information relating to the connection of these luminaires to dimming systems, refer to LED products at
