Digikeijs DR5033, Инструкция по эксплуатации

Страница: 7 / 18

DR5033 DIGIBOOST
P 7
www.digikeijs.com
® R-Bus, B-Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz
Stand 2019-10-14
3.1 LocoNet® Variables (LNCV) Table
LNCV Descrip on range Default LNCV Descrip on range Default
0 Loconet module address 1-9999 1 12
Wai2ng 2me
a@er
automa2c polarity reversal of the track
out before a short circuit is reported to the control unit.
(SePng in 3 millisecond steps.) 32-250 48
1
Firmware version (1000 = 1,000)
(Value can only be read)
- - 13
Wai2ng 2me before polarity reversal or short-circuit signal.
(SePng in 3 millisecond steps.)
16-250 32
3 Configura2on LNCV siehe unten 92 14
Op2onal switching address for polarity reversal of the out-
put
0-2048 0
6
Temperature of the H-bridge in degrees °C
(Value can only be read)
0-150 - 15 Polarity reversal ON for feedback A 0-2048 0
7
Current load in %
(Value can only be read)
0-100 - 16 Polarity reversal ON for feedback B 0-2048 0
8 Turnout address for booster Individual switch-off 0-2048 0 17 Polarity reversal OFF for feedback D 0-2048 0
11
Wai2ng 2me un l restart aIer short circuit.
The default value corresponds to approx. one 3/4 second
(750 ms). (SePng is done in three millisecond steps.) 64-30000 244 18 Polarity reversal OFF for feedback E 0-2048 0
Bit Wert Descrip on Default Bit Wert Descrip on Default
0
0 Not used
0 4
0
Booster does not send a special LocoNet® message in case of
short-circuit shutdown.
16
1 Not used 16
Booster sends a LocoNet® message in case of a short circuit so
that the central unit can display which booster has been
switched off.
1
0 Track Out ac2ve as soon as an input signal is detected.
0 5
0 Track Out ac2ve without output polarity reversal (blue LED off)
0
2
Track Out ac2ve as soon as the GO/Stop bu3on of the control
unit is pressed or the connected switching address (LNCV 8) is
switched to green. 32 Track Out ac2ve Output reversed polarity (blue LED on)
2
0
Booster does not send 'GPON/GPOFF' L.NET report on short
circuit.
Automa c short-circuit repair is enabled.
4 6
0 Automa2c polarity reversal off
64
4
Booster sends 'GPON/GPOFF' L.NET report to headquarters. The
central determines when the track out is switched on again.
64 Automa2c polarity reversal on
3
0 Not used
8
7
0 Not used
0
8 Not used 128 Not used
3.2 Descrip on Configura on LNCV 3
With the LNCV 3 the behaviour (short-circuit behaviour, start behaviour, automa2c reverse polarity, etc.) of the booster can be adapted.