D i g i g r a m
How to check the installation
Once the driver and the cards are installed according to the procedure
described in this manual, you can verify that the card is properly installed and
works fine as follows:
•
Go to
<Start> <Programs> <Digigram>
and select Digigram Control
Center.
•
In the Digigram drivers window, select the General Information tab.
In the Modules Information window, you can see the Np Runtime
modules that have been installed and their versions.
•
In the Digigram drivers window, select the NP Diagnostics tab.
You should see here the icons of the cards you have installed.
If the card you have installed is listed:
•
Right click on the icon of the card.
•
Select Diagnostics, and Play sine. This plays in loop a sine Wave
signal on the outputs of the card.
You can also select Play file to play in loop a file of your choice
(PCM, MPEG layer 1, layer 2 or layer 3).
If the playback is correct, the card is correctly installed and works.
•
To stop the playback, right click on the card icon, and select Stop
Activities.
If the card is not displayed:
•
make sure you have installed the second group of boards driver,
from the np runtime installation.
•
make sure that the card is correctly inserted in the PCI slot, and
screwed on the PC chassis.
•
if necessary, uninstall np runtime package as described in this
manual, and re-install it.
If you have also installed the Wave driver, you should see the device in
Control panel, Sounds and multimedia:
•
Select the Audio tab.
•
PCX924
v2
OUT # 1 (PCX924-Mic OUT #1, PCX22
v2
OUT # 1) is
listed in Sound playback, preferred device,
PCX924
v2
IN #1 (PCX924-Mic IN #1, PCX924
v2
IN # 1) is listed
in Sound recording, preferred device.
•
Check from a multimedia application that you can use the card.
You can also check in the Digigram Control Center that the Wave driver for
the second group of boards is detected: select the Wave NP tab.
14
