P/N: CM430SIRG Rev 1.2
Page
7
Copyright © 2019
E&OE
Windows IP Configuration
Click on Start button and choose Settings.
1. Choose Network & Internet.
2. Click on Ethernet -> Change adapter options. ...
3. Click Internet Protocol Version 4 (TCP/IPv4), and then click Properties. ...
Warning:
Before changing any of the numbers, ensure you take note of the original settings, as
this will disconnect you from your normal network connection.
Digiflex does not take any responsibility for your PC configuration, if you are
not experienced in networking, please contact your IT person.
Figure 7: Windows PC IP Config Setup Page
CM430S Reset
The CM430S modules can be reset whilst powered up by using a thin screwdriver and sliding the Reset switch from
OFF to ON position, then after 2-3 seconds, back to the OFF position. This will reset the device IP to
192.168.1.254
CM430S Specifications
Part Number:
CM430S - RS485 LAN To Ethernet Module - Supporting Star Configuration
Operating Voltage:
10.5V D.C - 14.5V D.C. @ 150mA Max
Module Connection:
(RS485 LAN)
Ethernet Interface: 10 / 100Base-T, Half / Full Duplex
RS485 Signal: 2 wire Data+/-
Operating
Environment:
0˚ to 55˚C RH 5 to 80% at 30˚C non-condensing.
Certification:
EN55032:2012, EN55024: 2010.A1:2015,
EN61000-3-2:2014, EN61000-2-2:2013
Warranty:
3 years from date of manufacture (return to base).
In the interest of ongoing product development this
document is subject to change without notice.
