DigiDesign VENUE XO16, Руководство пользователя

Страница: 8 / 12

XO16 Analog/Digital Output Card 4
4
On Mix Rack’s back panel, locate output slot E.
5
Remove the card from its packing material. Hold the card by
its edges.
6
Gently slide the card into the output slot.
7
When the card is seated in its slot, use the captive thumb-
screws to secure the card to Mix Rack’s chassis in the back of
Mix Rack.
8
Secure the card to the front panel of Mix Rack using the four
mounting screws you removed earlier.
9
Find the Hub48 Board ribbon cable that corresponds to the
output slot in which you have installed the XO16 Card. The
Hub48 board’s five ribbon cables connect to the Input and
Output Expansion Cards.
10
Connect the ribbon cable to the card socket on the XO16
card.
Make sure the pins on the socket are correctly aligned with the
ribbon cable connector. Secure the connection by moving the
retaining clips on each side of the socket connector inward.
Check to make sure the ribbon cable is connected securely.
If you are installing the XO16 Card in a slot with a card
slot cover, you must first remove the card slot cover.
Mix Rack back panel
Output
slot E
Do not remove or re-seat the ribbon cable connections on
the Hub48 Board while the board is installed in the Mix
Rack. This may cause excessive flexing of the Hub48 Board.
If necessary, disconnect the Hub48 and all input and out-
put card ribbon connections, and remove the entire assem-
bly from the rack prior to changing connections.
Detail of back of Mix Rack, the Hub48 Board, and the ribbon cables
Mix Rack contains 5 ribbon cables that connect to the input
and output cards. The top two ribbon cables connect to the
output cards installed in Output Slots D and E.
A properly connected Expansion Card
Connects to card
Connects to card
in Output Slot E
in Output Slot D
Hub48 Board