DigiDesign RM1, Руководство пользователя

Страница: 18 / 32

Digidesign RM1 and RM2 Guide 12
Channel Assign Switches
When using digital input, you must configure
the Channel Assign switches on the back of each
monitor to set whether that monitor plays the
Left or Right signal channel, accordingly.
To connect a digital source:
1
Connect an AES cable (XLR) to the AES 3 Dig-
ital In port on the back of one of your monitors.
This becomes the master monitor.
2
Connect one end of the included RJ45 cable to
the THRU port of the master monitor.
3
Connect the other end of the RJ45 cable to the
IN port of the other monitor.
4
Set the back panel Channel Assign switch to L
(Left) or R (Right) as appropriate for the location
of each monitor.
Connecting Analog and Digital Audio
Simultaneously
Though you can leave multiple inputs con-
nected simultaneously, digital input takes prior-
ity over analog. Whenever a valid digital input
is detected, the analog input is muted. Addi-
tional rules apply when using both digital input
formats, or all three (analog and both XLR and
RJ45 digital).
Digital Input Mode
Whenever a valid digital source signal is de-
tected at the AES IN or RJ45 IN ports, digital in-
put is selected. Analog Balanced IN is muted.
AES input takes priority over RJ45 input if both
are connected and receiving valid digital signal.
The RJ45 THRU port passes data in all digital in-
put modes.
To switch from RJ45 to a valid AES3 input:
1
Power down the monitor. Allow 10 seconds
for it to completely shut down.
2
Power the speaker back on again.
Analog Input Mode
Analog Balanced IN is enabled whenever there is
no valid digital source present at the AES or RJ45
digital inputs. No digital input or THRU occurs
in analog input mode.
Channel Assign switch