Spirit Digital 328 v2.0
8
8
8
8
2)
In the Peripherals window, select
“MIDI Controllers.”
1)
In the Peripherals window, select “Synchronization.”
2)
Check Machine Control.
4)
Make sure you are transmitting MMC commands from the 328 and proceed to the next section.
NOTE: If you plan to enable control of Bank-Shifting, Plugin parameters, or Aux
controls, please refer to Page 9 for important information regarding Transport
Control.
Enabling Peripherals
Enabling Peripherals
Enabling Peripherals
Enabling Peripherals
1)
From the SETUPS menu,
select PERIPHERALS
Choose “PC-1600” as the
controller type.
Receive from MIDI channels 15
and 16 respectively.
Send the output of the first device
to “Digital 328 channel 15.”
The output of the second “device”
goes to our “phantom” unit in OMS.
MIDI Machine Control
MIDI Machine Control
MIDI Machine Control
MIDI Machine Control
3) Set device ID to 127 (all).
A word about Pro Tools, OMS and MMC
Pro Tools will respond to PLAY, STOP and
RECORD commands without fault. However,
REWIND and FAST FORWARD commands are
not received well via MMC, because of the nature
of these commands. Pro Tools responds to
“held” commands, such as a REW or FF button
that transmits until released. At this time MMC
does not support a shuttle “hold” function.
Record Arm commands sent from the 328 are
not recognized in OMS 2.38 and earlier. OMS will
not pass these signals to Pro Tools.
