Digi TransPort LR54-AA401, Руководство пользователя

Страница: 23 / 169

Interfaces
TransPort LR User Guide 28
Ethernet interfaces
The Ethernet interfaces can be used as WAN or LAN interfaces. There is no IP configuration set on the
individual Ethernet interfaces. Instead, the IP configuration is done on the WAN and LAN interfaces.
Related topics
Configure Ethernet interfaces on page 28
Show Ethernet status and statistics on page 29
For more information on WAN interfaces and their configuration, see Wide Area Networks (WANs) on
page 52
For more information on LAN interfaces and their configuration, see Local Area Networks (LANs) on
page 46
Related commands
eth on page 156
show eth on page 186
Configure Ethernet interfaces
To configure an Ethernet interface, you must configure the following items:
Required configuration items
n
Enable the Ethernet interface. The Ethernet interfaces are all enabled by default.
Additional configuration options
The following additional configuration settings are not typically configured to get an Ethernet
interface working, but can be configured as needed:
n
A description of the Ethernet interface.
n
The duplex mode of the Ethernet interface. This defines how the Ethernet interface
communicates with the device to which it is connected. The duplex mode defaults to auto ,
which means the TransPort LR device negotiates with the connected device on how to
communicate.
n
The speed of the Ethernet interface. This defines the speed at which the Ethernet interface
communicates with the device to which it is connected. The Ethernet speed defaults to auto ,
which means it negotiates with the connected device as to what speed should be used.
From the command line
1. Enable the Ethernet interface. By default, all of the Ethernet interfaces are enabled.
eth 1 state on
2. Optional: Set the description for the Ethernet interface. For example:
eth 1 description “Connected to DSL WAN router”