3
RJ-45 10/100 Dual Speed Ports
There are 8 RJ-45 ports on the front panel. The speed
of the port is automatically determined when you
connect the hub to 10Base-T and 100Base-TX
devices.
Uplink Port
One uplink port (MDI) on the front panel allows users to
connect to a switch or a hub, using straight-through
Category 5 twisted-pair cable as figure shown.
Connecting to a desktop
The hub is connected to the desktops, to form a small
network. You can build the network as the figure shows.
Connecting to a Switch or a Hub
Hub-to-hub connections are made by connecting the
uplink port of the 10/100 dual speed hub to a port of the
other hub/switch.
With 100Base-TX, the maximum network distance is
approximately 205 meters with UTP cable. The maximum
length between hubs or switch-to-hub is 100 meters.
W
ALL MOUNT
The MIL-H3130 10/100 Dual Speed Hub can be mounted to the wall
or to a flat surface.
!
Screw one of the enclosed 1/2-inch wood screws
into the surface, leaving approximately 1/4-inch of
the threads exposed.
!
Hang the hub on the wall using the keyholes
provided on the bottom of the hub.
F
CC COMPLIANCE STATEMENT
This equipment generates and uses radio frequency
energy and if not installed and used properly, that is, in
strict accordance with the instructions provided with the
equipment, may cause interference to radio and TV
reception. The equipment has been tested and found to
comply with the limits for a Class A computing device in
accordance with the specifications in Subpart B of Part 15
of FCC rules, which are designed to provide reasonable
protection against such interference in a residential
installation. However, there is no guarantee that
interference will not occur in a particular installation.
If you suspect this equipment is causing interference, turn
your hub on and off while your radio or TV is showing
interference. If the interference disappears when you turn
the hub off and reappears when you turn the hub on,
something in the hub is causing interference.
You can try to correct the interference by one or more of
the following measures:
•
Reorient the receiving radio or TV antenna where
this may be done safely.
•
To the extent possible, relocate the radio, TV or other
receiver away from the equipment.
•
Plug the computer which has the equipment installed
into a different power outlet so that the equipment
and the receiver are on different branch circuits.
Wall
